How To Properly Create a European Skull Mount With Your Deer

 So you've just bagged a large 8 point buck and you're wondering how to make it mounted? Wonder no further because European skull mounts are getting good popular every season. They're cheaper and arguably better looking than traditional shoulder mounts. Plus, it's also possible to get the materials to make it yourself for relatively cheap.

Having your deer, use an art and craft saw and prepare a clean cut right behind the top of the deer's head. For those who don't have time to decontaminate the skull then simply place the head within a trash bag and maintain it within a freezer until later.

Once you're ready to get started, have a tall boiling pot and placed the deer head inside. Guarantee the boiling pot is tall enough where the deer's nose isn't touching the bottom. Now fill the pot with water until it's covering everything however the horns. It's not good to boil the horns nonetheless it won't hurt if the stream is touching a little. Now heat the stream to a sluggish boil. You don't want a quick boil because this will likely can damage the skull and even cause teeth to fall out. You'll have to permit the skull boil for much time before it's fully clean. It's sound practice to test it every 1.5-3 hours in order to scrape off any big chunks of meat and refill the lost water caused by evaporation.

When you've removed everything you possibly can by boiling, make skull out and employ a hose with a wire brush to remove any remaining meat. When merely the skull and horns remain, use 40 or 50 volume peroxide to whiten it up. You should buy the peroxide any most beauty salons. When I went in to buy mine, the woman saw my camouflage and Polar Bear mount for sale if I had been there for peroxide to not even need to ask where it is.

Now got some latex gloves and grab a classic toothbrush. Be aware because these products will burn a bit when it enters into connection with your skin. Coat the skull with the peroxide then allow it to set for some minutes. Rinse it off and repeat until it's your desired hue of white.

Once your skull is finished and cleaned, drill a 3/8" hole with your mounting board plus abdominal muscles back in the deer skull. Placed the toggle bolt through the back of the mounting board and through the back of the deer skull. Make sure the bolt comes unlatched inside skull and tighten the screw until things are secure. Now you're done!

In the event you follow these directions, you ought to have a good looking European skull mount to display in the living room, office or man cave. They're a sensible way to showcase your kill you'll also find the satisfaction of telling others that you made it happen yourself. Happy hunting!